Sargent L980S & 12-L980 Keyed Removable Mullions Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sécurité Sargent L980S & 12-L980 Keyed Removable Mullions. SARGENT L980S & 12-L980 Keyed Removable Mullions User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
INSTALLATION INSTRUCTIONS FOR
L980S & 12-L980 STEEL MULLIONS
FOR ASSISTANCE CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
Tools Required:
· Measuring Tape
· Pencil
· Drill & Tap Sizes: #7 drill and 1/4"-20 tap
· Concrete Drill: 3/8" diameter
· Center Punch
· Hammer
· #3 Phillips Screw Drivers
· 5/64" Allen Wrench
· 1/8" Allen Wrench
To install mullion in frame
1. Close and block the doors against the frame stops. Check gap
between door leaves and door to frame and correct if necessary.
2. Locate the center of the opening on the floor. Using the bottom
retainer mark the positions for the two drop-in fasteners.
a. The bottom of the door should come to rest against the
surface of the mullion.
b. Modify threshold as required.
3. Drill holes with 3/8" diameter cement bit to a minimum depth
of 2-1/2".
4. Fasten bottom bracket to floor.
5. Locate the center of the opening on the top of the frame.
Using the top retainer mark the positions for the four fasteners.
a. The door should evenly rest against both the frame stop
and the mullion.
b. If a top retainer mounting kit is used, modify
weather-stripping as required.
6. Drill and tap each location for 1/4"-20 fasteners.
7. Mount top retainer on frame with provided fasteners.
8. Measure “Dim X” as shown. Remove material from the
bottom of the mullion per the formula:
length of mullion = “Dim X” minus 3/4".
Note–This leaves approximately 1/8" clearance between the
mullion and the top bracket when mounted.
9. Place mullion onto bottom bracket and pivot into opening to latch.
10. Tighten bottom bracket set screw to prevent mullion rattle.
11. Install exit devices according to manufacturer’s instructions.
© SARGENT Manufacturing Company All rights reserved A7111C
Dim “X”
Vue de la page 0
1 2

Résumé du contenu

Page 1

INSTALLATION INSTRUCTIONS FOR L980S & 12-L980 STEEL MULLIONSFOR ASSISTANCE CONTACT SARGENT AT 800-727-5477 or www.sargentlock.comTools Required:·

Page 2

ASSEMBLY INSTRUCTIONS FOR L980S & 12-L980 STEEL MULLIONS© SARGENT Manufacturing Company All rights reserved A7111CKeywayCylinderBlocking Ring5

Commentaires sur ces manuels

Pas de commentaire