Sargent 7 Line Manuel d'utilisateur télécharger pdf

CONTROL

KEY

1. Rotate bottom plug until notch lines up with indicator dot

on top plug.

2. Pull bottom plug straight out, then remove top plug.

Important- Save tail piece on back of construction plug to be

reused with cylinder.

REMOVING DISPOSABLE PLASTIC PLUGS

REMOVING CYLINDER CORE

INSERTING CYLINDER CORE

NOTE: Tail piece or pins version construction can be used

depending on lock. See reverse side for description.

1. Insert top plug into top hole in lever.

• If pins version insert bottom plug with notch facing horizontal

on to pins.

• If tail piece version insert the tail piece into the bottom plug

then insert bottom plug with notch facing horizontal into lever.

INSERT DISPOSABLE PLASTIC PLUGS

CYLINDER

WITH TAIL PIECE

1. Insert control key

2. Turn clockwise until stop is reached

3. With key in this position–pull out core

4. To remove key–return to horizontal position

and withdraw

NOTE: If a control key is needed for one bitted removable core

(63-) cylinders, cut a key blank from bow to tip using 113511.

NOTE: Tail piece or pins version construction can be used

depending on lock. See reverse side for description.

1. A) Tail piece version - The tail piece should be inserted

into back of cylinder. (Use tail piece stamped “6” if 6 pin

cylinder and “7” if 7 pin cylinder.) See figure A

B) Pins version - Rotate the pins gently to 15 degrees

offset. See figure B.

2. Then insert control key into replacement core and insert

cylinder into lever

3. To remove key–return to horizontal position

and withdraw

NOTE:

For easier removal hold core in

place while starting to withdraw key.

INSTALLATION INSTRUCTIONS FOR

7 and 10 Line Levers with SARGENT Removable Core (63-)

or Arrow, Best and Falcon Interchangeable Core

FOR INSTALLATION ASSISTANCE CALL SARGENT AT 1-800-727-5477 • www.sargentlock.com

BOTTOM

PLUG

NDICATOR

OTCH

TOP PLUG

LEVER

TAIL PIECE

(

6 OR 7 PIN)

LEVER

PINS

15°

PINS

OP PLUG

BOTTOM

LUG

FIGURE A

FIGURE B

PINS

VERSION

CORE

CONTROL

KEY

LEVER

A6847E

Reproduction in whole or in part without the express written

permission of SARGENT Manufacturing is prohibited.

1 2

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS FOR

CONTROLKEY1. Rotate bottom plug until notch lines up with indicator doton top plug.2. Pull bottom plug straight out, then remove top plug.Important- S

Page 2 - INSTALLING LEVER

1. REMOVE CYLINDER (REFER TO BACKSIDE OF THIS PAGE).2. INSERT FLAT-BLADE SCREWDRIVERINTO LEVER BETWEEN PINS.3. GENTLYTURN SCREWDRIVER 45 DEGREESCLOCKW